Guest viewing is limited

Potterton Promax 15 HE

  • Thread starter MethodPH
  • Start date
  • Replies 1
  • Views 42
M

MethodPH

Potterton Promax 15 HE
Been called out to an issue with a Potterton Promax 15 HE. Boiler fires up and runs for 30 seconds, no heat leaves the boiler, then you get loads of clunking which sounds like air/crap. Then flow and return get red hot and it cuts out. Have disconnected flow and returns from boiler and and checked that water passes through the boiler without obstruction, which it does. Have checked where cold feed and vent enter the system no blockage there. Pumps working. Have tried draining down and refilling, fills fine but still get the same issue. Any ideas would be appreciated. I’m gas safe registered

Continue reading...
 
I believe these boilers regularly have problems that are down to poor soldered connections on the PCB. Might be worth checking this out and re-soldering anything that looks dodgy.
Good luck!
 
Back
Top