Old PIR reuse with Texecom Premier Elite

Old PIR reuse with Texecom Premier Elite

Old PIR reuse with Texecom Premier Elite

Hi,

I'm looking to connect existing wired PIRs in to a new Texecom Premier Elite 48 panel. The current PIRs have resistors which can be changed with jumpers (currently set as 4k7 for Tamper and 6k8 for Alarm - see attached).

When connected to the Texecom panel and configuring in Wintex, should I configure the zone as Double Pole/EOL or change the resistor value in the PIR to 2k2 for Tamper and 4k7 for alarm and then set in Wintex as 2k2/4k7/(6k8)?

Thanks in advance.

by MM456

This has been automatically posted in the DIYNot Forum on DIY Talk. The new DIY Forum