Ledger board straddling gas pipe and cable

  • Thread starter Mark Huddleston
  • Start date
  • Replies 0
  • Views 94
Ledger board straddling gas pipe and cable

Ledger board straddling gas pipe and cable

I’m planning to construct a ceiling in the garage. I’ll be attaching a ledger plate with concrete screws or resin bolts to use joist hangers. The board has to “straddle” the gas pipe and electrical cable/conduit. It will be where the red line is marked in the photo. Can I notch the timber in 2 places around them so it’s one continuous length or can it be constructed in 3 separate sections? Planning to use 45 x 120mm timber but will need to notch out 35mm so doesn’t leave much meat if it has...

Read more

by Mark Huddleston

This has been automatically posted in the DIYNot Forum on DIY Talk. The new DIY Forum
 
Back
Top