Altered header pressure resulted in reduced capacity
Altered header pressure resulted in reduced capacity
Hi
Im new
I may amuse any experts with what follows
i sawed in half a vented direct immersion boiler (which supplies hot water in property with eco7) and elevated the feeder tank into the loft. Both the tanks are intact (no new openings). I reconnected the severed pipework, the only difference is the header tank sits 25cm higher than it used to relative to the heater tank. Both tanks are 70cm higher relative to the taps. I didnt opt to move entire system to minimise heat loss in cold attic...
Read more
by Boobah
This has been automatically posted in the DIYNot Forum on DIY Talk. The new DIY Forum
Altered header pressure resulted in reduced capacity
Hi
Im new
I may amuse any experts with what follows
i sawed in half a vented direct immersion boiler (which supplies hot water in property with eco7) and elevated the feeder tank into the loft. Both the tanks are intact (no new openings). I reconnected the severed pipework, the only difference is the header tank sits 25cm higher than it used to relative to the heater tank. Both tanks are 70cm higher relative to the taps. I didnt opt to move entire system to minimise heat loss in cold attic...
Read more
by Boobah
This has been automatically posted in the DIYNot Forum on DIY Talk. The new DIY Forum